Aleddras third-generation double-ended EasiRetrofit® Dimmable LED T8 tube lamp is dimmable using standard TRIAC based dimmer switches. It has been UL classified according to the latest 1598C safety standards. It is an ideal energy saving replacement for traditional T12 and T8 fluorescent lamps. The Aleddra G3 dimmable double-end T8 LED tubes come with an internal, field replaceable driver - this patented design minimizes the repair and replacement downtime in the field, and also doubles the lifetime of the LED tube to 10 years at a third of the cost of a new tube replacement. The Aleddra G3 T8 LED tube lights are also cULus Listed.
Only Aleddra offers a safe alternative that is also energy efficient; a double-end power LED T8 tube with integral safety switches. Aleddras dimmable LED T8 tubes utilize a safety switch on each of the two end-caps on the tube. When operating with the line voltage, the safety switches on the end-caps protect the installer from electric shock, meeting UL 1598C safety requirements. The safety switches will only allow the circuit to be completed when both end-caps are in position, locked in both sockets and energized. This patented safety design completely eliminates the risk of shock to the installer.
Aleddras double-end dimmable LED T8 tubes are voltage SPECIFIC and this particular model operates directly from 120 volt AC line voltage (Note: when operating on direct AC line voltage these double-end LED T8 tubes require the sockets on BOTH ends to be energized - see the wiring diagram to the right). You must remove or bypass the ballast and wire the sockets directly to the AC line voltage. After removing/bypassing the ballast connect one of input lines with the wire(s) connected to one electrode on the fixture using a UL approved 18-14 AWG (0.82-2.08 mm2) twist-on wire connector(s) and then repeat the procedure for the other electrode. These dimmable LED T8 tubes may be installed in either shunted or non-shunted medium bi-pin G13 lamp holders, thus saving 50-70% installation time and associated labor costs compared to retrofits using standard single-ended LED tubes.
This item is the Aleddra LLT-4-T8-C-SW-120-DM1-D-10-50K. It is a 4 foot LED T8 retrofit tube that consumes 18 watts of 120VAC input power and generates 1,800 lumens of 80 CRI 5000K light output. The lens is clear and light output is at a 120 degree beam angle. The operating temperature range is -20 degrees Fahrenheit to +122 degrees Fahrenheit. The LLT-4-T8-C-SW-120-DM1-D-10-50K has a rated life of 50,000 hours (at L70 standards) and it carries a 5 Year Limited Warranty. This Aleddra G3 dimmable T8 LED Tube light is cULus Listed.
|LED Color||5000K Daylight|
|Beam Angle||120 Degrees|
|Rated Life||50,000 Hours (L70)|